Installation Of The Charging Station - Husqvarna Automower 230 ACX Operator's Manual

BvAM220-230_2013_US.book Page 18 Thursday, December 4, 2014 3:03 PM
• Loop wire for the boundary wire and guide wire
(18)
• Transformer (19)
• Low voltage cable (20)
• Staples (21)
• Connector for the loop wire (22)
• Screws for the charging station (23)
• Measurement gauge (24)
• Solderless coupler for the loop wire (25)
During installation you will also need: A hammer to
knock the staples into the ground, combination pliers,
polygrip (for pressing the couplers together) and a
straight spade if the boundary wire is to be buried.
3.2 Installation of the charging
station
Ideal position of the charging station
For examples of good positioning of the charging
station, see 7. Garden example - Proposed installation
and settings on page 61.
If you are going to install a guide wire, read 3.8
Installation of the guide wire, see page 32, before
choosing the position of the charging station.
The charging station must be positioned with a great
deal of free area in front of it (at least 10 ft
(3 metres)). It should also be positioned centrally in
the working area so that Automower
the charging station and quickly reach all parts of the
working area.
It is a good idea to place the charging station in the
shadow. The battery is spared if it is charged in the
lowest possible ambient temperature.
The charging station must be positioned on relatively
level ground. The height difference must not differ
more than 2" (5 cm) between the front and rear of the
charging station.
The charging station must not be positioned so that
its plate bends.
18 - English
3. INSTALLATION
can easily find
®