Husqvarna Automower 230 ACX Operator's Manual page 35

BvAM220-230_2013_US.book Page 35 Thursday, December 4, 2014 3:03 PM
5. Route the guide wire at least 7 ft (2 metres)
straight out from the front edge of the charging
plate.
If you shall install the guide wire through a passage:
• Automower
®
side of the wire both to and from the charging
station. This means that in towards the charging
station the guide wire is on the right side of the
mower and away from the charging station the
guide wire is on the left side of the mower.
In the passage, the guide wire must be placed so
that the mower has as much space to run as
possible. The distance between the boundary
wire and the guide wire must however be at least
12" (30 cm) (see the picture above).
The same minimum distance (12" (30 cm)) also
applies between the guide wire and the guide
wire in the passage,
Avoid laying the wire at sharp angles. This can make
it difficult for the mower to follow the guide wire.
6. Run the guide wire to the spot on the boundary
wire where you want to make the connection.
7. Lift out the boundary wire.
8. Cut off the boundary wire using a pair of wire
cutters.
3. INSTALLATION
follows the guide wire on the same
Maximum
distance
At least 12"
At least
7 ft
135º
135º
90º
English - 35