Environmental Information; Removing The Battery For Recycling - Husqvarna Automower 230 ACX Operator's Manual

BvAM220-230_2013_US.book Page 77 Thursday, December 4, 2014 3:03 PM

12. ENVIRONMENTAL INFORMATION

12. Environmental
information
The symbol on Husqvarna Automower or its
®
packaging indicates that this product may not be
treated as household waste. It should instead be left
at a suitable recycling centre to recycle its electronic
components and batteries. Contact your dealer for a
disassembly of the batteries.
By ensuring this product is disposed of correctly, you
will help prevent potential negative consequences for
the environment and human health, which could
otherwise be caused by inappropriate waste handling
of this product.
For more detailed information about recycling of this
product, please contact your local council office, your
household waste disposal service or the shop where
you purchased the product.
12.1 Removing the battery for
recycling
Follow these steps to remove the battery from the robotic lawnmower.
Disassembling the body
The body is fitted to the chassis using four quick-mounted, snap-on brackets. The charging cable fastened
to the body's charging strip must be disconnected to be able to remove the body entirely from the chassis.
Set the main switch to position 0.
Clean the area around the grommet for the charging cable found at the very front under the mower.
Pull out the rubber grommet on the charging cable and carefully loosen the connector.
Loosen the body from the chassis by lifting the body one corner at a time while holding the chassis in
place.
Disassembling the chassis
Loosen all 14 screws (Torx 20).
Remove the guarantee seal at the point of_separation between the chassis halves on the right-hand side.
Carefully lift the back edge of the upper section of the chassis.
Disconnect the MMI cable from the main circuit board and remove the upper section of_the chassis.
Disassembling the battery
Loosen the three screws (Torx 20) holding the battery cover in place.
Disconnect the battery connection from the main circuit board.
Open the battery cover and remove the battery.
English - 77