Technical Information - Siemens miniTek User Manual

Technical information

Tek remote control
FCC: SGI-WL200AP
Operating frequencies: F =3.28 MHz
c
Max. field strength @ 10m: -24.1 dBμV/m
Max. field strength @ 30m: -6.2 dBμV/m
miniTek remote control
FCC: SGI-WL500
Operating frequencies: F =3.28 MHz
c
Max. field strength @ 10m: -24.1 dBμV/m
Max. field strength @ 30m: -6.2 dBμV/m
FCC compliance information can be found inside the battery
compartment or on the back of the instrument.
Changes or modifications not expressly approved by the party
responsible for compliance could void the users authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
46
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Siemens transmitter
IMPORTANT NOTE: IC Radiation Exposure Statement: This
equipment complies with IC radiation exposure limits set
forth for an uncontrolled environment.
47