Paper Jam Detector - Sharp AR-C360P Service Manual

2.8

Paper Jam Detector

The AR-C360P detects paper jam during printing after turning on the power source. If there is any paper
jam detected, the printing process is immediately canceled. In this case, open the cover, remove the
paper that is jammed, and close the cover to resume printing.
Error Code Displayed on LCD
400,401 Paper Size Error
372 Mis-feeding in Double-Side
Print Conveyance Assy
390 MT mis-feed.
1-391 Cassette 1, 2, 3, 4 or 5 mid-
2-392 feed.
3-393
4-394
5-395
370 Paper jam when printing on
the other side with Double-
Side Print.
383 Paper jam at the entrance
of the Double-Side Printer
Unit.
371 Paper jam at the input of the
Double-Side Printer Unit.
382 Paper discharge jam.
381 Paper conveyance jam
380 Paper output jam.
490 MT out of paper.
1-491 Cassette 1, 2, 3, 4 or 5 out
2-492 of paper
3-493
4-494
5-495
382
Double-side print
entrance sensor
370
Double-side print rear sense
Rev. 1
Error
Discharge
381
conveyor
Discharge sensor
371
Double-side
383
print entry
Double-side print
front sensor
Double-side print rear sense
After the Entrance Cassette Sensor turns ON, it
won t turn OFF for a certain period of time. It detects
several different types of paper sizes.
Failure to feed paper from the Double-Side Print
Conveyance Assy.
Paper feed from the MT failed. (If, after Hopping, the
Entrance MT Sensor does not turn ON within a
certain period of time)
Paper supply failed from Cassette 1, 2, 3, 4 and 5.
(If, after Hopping, the Entrance Cassette Sensor
does not turn ON within a certain period of time)
The double-side printer rear sensor does not turn
ON when printing the other side with the double-side
printer unit.
The double-side printer IN sensor does not turn ON
when supplying paper to the double-side printer unit.
The double-side printer front sensor does not turn
ON while the double-side printer unit is operating.
The paper discharge sensor senses the tip of the
paper but does not sense the end of the paper after
that within a certain period of time. The paper
discharge sensor turns ON, but does not turn OFF
after that.
The paper is conveyed on the belt, however, the
paper discharge sensor does not turn ON.
After hopping is completed, the paper does not
reach the entrance belt sensor or the MT sensor.
If printing is started when the MT is out of paper.
Cassette 1, 2, 3, 4 or 5 out of paper
Entrance belt sensor
Entrance MT sensor
Paper
Paper feed
380
Double-side print input
Cassette 1
Cassette 2
Cassette 3
Cassette 4
Cassette 5
State
Multipurpose tray part
(MT)
390 Mis-feed in MT
Entrance cassette sensor
372 Mis-feed in double-sided printing
391 Mis-feed in a cassette 1
Mis-feed in a cassette 2
392
393 Mis-feed in a cassette 3
Mis-feed in a cassette 4
394
395 Mis-feed in a cassette 5
39/