Sharp AR-C360P Service Manual page 118

[How to Initialize the Network Information]
(1) Turn OFF the printer.
(2) If the network cable is connected to the printer, disconnect the cable from the printer-side.
(3) Press the black push switch ([Test] Button) on the NIC Card, and turn on the print.
Continue to press the black push SW until the following message appears on the top row
of the operation panel "One Moment" or the following message appears on the bottom
row "Initializing network".
There is no longer any need to press the black push SW once the above is displayed.
(4) Initialization is completed if "Ready to Print" appears on the operation panel.
For 1200dpi, NIC Card
Note
[Procedure to Check that Network Information Has been Initialized]
(1) Printer the "Printer Information" and "Setting Details".
(2) Check the following 2 points in the "Network" area of the first sheet of the results printed
for the setting details.
Slot: 100/10 Base
IF the
fully initialized.
Rev. 1
MAC Address
Short Printer Nam
number value is the same (3 bytes), the network information has been success-
118 /