Sharp AR-C360P Service Manual page 140

Hide thumbs Also See for AR-C360P:
Table of Contents

Advertisement

2-4 Paper Output Jam
• Immediately after turning ON the power, does a paper output jam occur?
• YES
• NO
• YES
• YES
• NO
Is the Face-Up Stacker cover fully open? Or is it completely closed?
NO
• YES
Is the heat motor operating?
• NO
• YES
• YES
• YES
Does the paper output guide Assy operate normally?
NO
• YES
Replace the engine PCB.
Rev. 1
Is there a jam with the paper output sensor?
YES
Remov-e the paper jam.
Does the paper output sensor lever operate normally?
NO
Replace the paper output sensor lever.
Does the paper output sensor operate normally? (Activate the sensor lever.
Then check to see that the sensor operates normally with the switch scan
test in the Maintenance Mode. Or check Engine PCB (S2V PWB) connector
PART TEMP Pin 8.)
NO
Check signal cable connection, then replace the paper output sen-
sor.
Replace the engine PCB.
Fully open or close the stacker cover.
Heat Motor resistance the rated value of approx. 7.9Ω?
NO
Replace the heat motor.
Is 34V output to the Engine PCB power connector 12 to 14 Pin?
NO
Replace the low voltage power unit.
Check the cable connection, then replace the engine PCB.
Replace the paper output guide Assy.
140 /

Advertisement

Table of Contents
loading

Table of Contents