Sharp AR-C360P Service Manual page 127

Display Cause
Service Call Thermistor
173: Error indicates Low
177: Error Temperature
(COLD) Error.
Service Call Wrong Fuser
179: Error Standard
Service Call The engine
180: Error detects commu-
to nication is not
186: Error possible with the
optional unit.
180: Envelope
Feeder
(Unused)
181: Duplex unit
182: Tray2 unit
183: Tray3 unit
184: Tray4 unit
185: Tray5 unit
186: Finisher unit
Service Call Communication
187: Error with control
panel failed.
Service Call Sub-CPU I/F
188: Error Error
Service Call Inverter Unit I/F
189: Error Error
Service Call System Memory
190: Error Overflow
Service Call PU Firm
200: Error Download Error
to
202: Error
POWER Custom Media
OFF/ON Table Download
209: Error
DOWNLOAD
ERROR
Service Call CU Program
203: Error Dysfunction
to
208: Error
210: Error
to
214: Error
0×FOC: Error
0×FOD: Error
0×FFE: Error
0×FFF: Error
Service Call Print Satistic
220: Error mismatch
Service Call
RFID Reader
230: Error not Installed
Rev. 1
Table 7-1-1 Operator Alarm (5/10)
Error Description and Analysis
1) Is an Error message
displayed?
2) Does the Error take place
again?
1) Is the model and power
voltage of the fuser
mounted proper?
2) Fuser is properly mounted,
but Error results again.
1) Is an Error message
displayed?
2) Does the Error take place
again?
Is the control panel and
cable connected properly?
Sub-CPU Communication
Error
1) Inverter communications
error
2) Does the Error take place
again?
System Memory Overflow
Error occurred when
downloading PU firmware.
Failed to download custom
media table.
Detected illegal process with
CU program.
HDD was removed or
replaced after print statistic is
set to ON.
1) RFID read device error
2) Does the Error take place
again?
Remedy
judgment
Yes Turn ON power again.
Yes Leave in that state for 30
minutes then turn ON power
again.
No Assemble the proper fuser.
Yes Check to see that the fuser
is properly assemble.
Yes Replace fuser.
Yes Turn ON power again.
Yes Replace optional unit.
No Connect properly
Yes Replace the control panel
and cable.
Check the connection of the
S2M board.
Replace the S2M board.
Yes Check the connection of the
I/F cable.
Yes Replace the V72-3 board.
Power OFF/ON
Replace CU PCB. (Replace
EEPROM)
After turning ON the power
again, try downloading again.
(This process isn't executed
for regular operations,
therefore, will not occur)
After turning ON the power
again, try downloading again.
(This process isn't executed
for regular operations,
therefore, will not occur)
Yes Write down the 24 digit
number displayed on the
LCD panel and report it.
Turn OFF the power. Then
check the insertion of the CU
board. Now turn ON the
power again.
Get the original HDD back.
Yes Check the connection of the
RFID R/W board.
Yes Replace the RFID R/W board.
Replace the S2V board.
1200
✓
✓
✓
✓
✓
✓
✓
✓
✓
-
✓
✓
127 /