Sharp AR-C360P Service Manual page 129

Display Cause
Reset the belt After turning ON
330: Belt Error the power or
when cover is
closed, the sensor
detects that the
unit is missing.
Reset the After turning ON
drum the power or when
340 to 343: cover is closed, the
Drum Error sensor detects that
the unit is missing.
Replace with a ID Unit Life
new drum
350: Yellow
Drum Life Near-
End
351: Magenta
Drum Life Near-
End
352: Cyan Drum
Life Near-End
353: Black
Drum Life Near-
End
Replace with Fuser Life (This
a new fuser takes place
354: Fuser when the fuser
Life Near- life is continu-
End ally OFF)
Replace with Notify Belt Life
new belt (Alarm)
355: Belt Life Print N-count
Near-End worth by
opening/closing
cover.
Replace with Notify the Disposal
new belt Toner Full Belt
356: Belt Life Life (Alarm).
Near-End Print N-count
worth by open-
ing/closing cover.
N=20
Replace with If the Double-
new double- Side Printer
side printer unit Unit is disas-
360: Double- sembled from
side printer unit this machine.
is open
Check Duplex Paper jam detected
370: Paper in double-side
Jam printer unit when
turning over paper.
Check Duplex Paper jam
371: Paper detected in
Jam double-side
printer unit.
Check Duplex Paper jam in
372: Paper paper supply
Jam from the
double-side
printer unit.
Rev. 1
Table 7-1-1 Operator Alarm (7/10)
Error Description and Analysis
1) Is an Error message
displayed?
2) Is the best unit properly
mounted?
3) Does the Error take place
again?
1) Is an Error message displayed?
2) Is the image drum properly
mounted?
3) Does the Error take place
again?
Is this immediately after
replacing the ID unit?
Is this immediately after
replacing the fuser?
Is this immediately after
replacing the belt?
Is this immediately after
replacing the belt?
Are operations restored by
re-inserting the Double-Side
Printer Unit?
Check paper jam in double-
side printer.
Check paper jam in double-
side printer.
Check misfeed in double-side
printer unit.
Remedy
judgment
Yes Check how the belt unit is
mounted.
No Re0mount the belt unit, then
turn ON the power again.
Yes Replace Belt Unit Assy
Yes Check how the ID is mounted.
Turn ON power again.
No Replace ID Unit Assy
Yes Check ID Unit Life
No Replace ID Unit
Yes Check Fuser Life
No Replace fuser.
Yes Check Belt Life
No Replace belt.
Yes Check Belt Life
No Replace belt.
Yes Normal
No Replace double-side printer
unit or replace engine PCB.
Yes Remove the paper jam.
No Check/replace double-side
printer unit.
Yes Remove the paper jam.
No Check/replace double-side
printer unit.
Yes Remove the misfed paper,
then close cover.
No Check/replace double-side
printer unit.
1200
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
129 /