JVC KD-LH7R Service Manual page 11

QQ
3 7 63 1515 0
Removing the clamper assembly
Prior to performing the following procedure, remove
the top cover.
1. Remove the clamper arm spring.
2. Move the clamper assembly in the direction of the
arrow to release the two joints d.
Removing the loading / feed motor
assembly (See Fig.11 and 12)
Prior to performing the following procedure, remove
the top cover, the connector board and the chassis
unit.
TE
1. Remove the screw C and move the loading / feed
L 13942296513
motor assembly in the direction of the arrow to
remove it from the chassis rivet assembly.
2. Disconnect the wire from the loading / feed motor
assembly if necessary.
CAUTION: When reassembling, connect the wire
from the loading / feed motor assembly
to the flame as shown in Fig.11.
www
.
http://www.xiaoyu163.com
eàYGNg u5•ïVþ•Q
(See Fig.9 and 10)
x ao
y
i
Loading / feed motor assembly
Fig.11
http://www.xiaoyu163.com
http://www.xiaoyu163.com
8
Clamper arm
spring
Joint d
Clamper arm spring
Joint d
Q Q
3 6 7 1 3
Chassis rivet assembly
Loading / feed motor assembly
C
u163
.
2 9 9 4 2 8
Clamper assembly
Joint d
Fig.9
Clamper assembly
Joint d
1 5 0 5 8 2 9 9 4
Fig.10
m
co
Fig.12
KD-LH7R
9 9
Chassis rivet
assembly
2 8 9 9
1-11