FUTABA T18MZ Instruction Manual page 78

Linking method (T18MZ
 %ULQJ WKH UHFHLYHU WR EH OLQNHG WR ZLWKLQ FP
RI WKH WUDQVPLWWHU
 3UHVV WKH >/LQN@ EXWWRQ LQ WKH >/LQN@ ER[ RI
>6\VWHP 7\SH@
 7KH WUDQVPLWWHU HPLWV D FKLPH VRXQG DQG HQWHUV
WKH OLQN PRGH
 7KH UHFHLYHU SRZHU LV LPPHGLDWHO\ WXUQHG
RQ$ERXW  VHFRQGV DIWHU WKH SRZHU LV WXUQHG
RQ WKH UHFHLYHU HQWHUV WKH OLQNLQJ VWDWH
5HFHLYHU OLQNLQJ WLPH LV DERXW  VHFRQG
 ,I OLQNLQJ LV VXFFHVVIXO WKH UHFHLYHU /(' FKDQJHV
IURP UHG WR JUHHQ WKH OLQN PRGH HQGV DQG WKH
UHFHLYHU ,' FRGH LV GLVSOD\HG
 ,I OLQNLQJ IDLOV DQ HUURU PHVVDJH LV GLVSOD\HG
%ULQJ WKH WUDQVPLWWHU FORVHU WR WKH UHFHLYHU DQG
UHSHDW WKH SURFHGXUH DERYH IURP 6WHS 
7RXFK WKH >/LQN@ EXWWRQ LQ WKH 6\VWHP 7\SH
0HQX WR FDOO WKH VHWXS VFUHHQ VKRZQ EHORZ
WARNING
Do not perform the linking operation when the
drive motor is connected and the engine was
started.
Inadvertent rotation of the motor or acceleration of the engine
LV H[WUHPHO\ GDQJHURXV
Once the link operation is complete, please check
that your receiver can be operated with the linked
transmitter.
78 <Linkage Menu>
R7008SB)
*Do not perform the linking operation when the drive motor is
connected or the engine is running.
* When you use two receivers, please be sure to setup a
"primary" and "secondary" in the "dual" mode.
*Since two sets of receivers cannot be individually recognized
without using a "primary" and "secondary" setup, it is
impossible to receive telemetry data correctly.
* You must link one receiver at a time. If both power supplies
to the receivers are switched on simultaneously, data is
received incorrectly by the transmitter.
* If a dual receiver function is used, in order to receive sensor
information correctly by both sets, telemetry data will be
slower compared to a single receiver setup.
* You cannot link three sets of receivers.
%DWWHU\ IDLOVDIH YROWDJH VHWXS RQO\
)$667HVW PRGH
5HWXUQ WR 6\VWHP 7\SH
Check operation sufficiently before flying after
linking.
If the same receiver is sending in the vicinity, there is the danger
that the transmitter may be linked with that receiver.
CAUTIONS
Always turn on the transmitter power after linking
is complete.
When pairing with the transmitter, be sure that a
previously linked transmitter is not transmitting
0HQX