Functions Of Linkage Menu - FUTABA T18MZ Instruction Manual

FUNCTIONS OF LINKAGE MENU

The Linkage Menu has all of the functions you
will need to perform model addition, model type
selection, frequency setting, end point setting, and
other model basic settings.
:KHQ \RX WRXFK WKH /LQNDJH 0HQX EXWWRQ RQ WKH +RPH
VFUHHQ WKH PHQX VKRZQ EHORZ LV FDOOHG XS 7RXFK WKH
EXWWRQ RI WKH IXQFWLRQ \RX ZDQW WR VHW
)RU D GHWDLOHG GHVFULSWLRQ VHH S &RQGLWLRQ +ROG IXQFWLRQ 
Linkage Menu functions table
[Servo Monitor]: Displays the servo test and operation position
[Model Select]: Model addition, call, deletion, copy, model name setting
[Model Type]: Model type, wing type, switch type, etc. selection
[Picture]: Picture selection and setting for each model
[Sound]: Sound recording and playback
[System Type]: System selection, receiver link, telemetry.
[Function]: Channel assignment of each function can be changed
[Sub-Trim]: Adjusts the neutral position of each servo
[Servo Reverse]: Servo direction reversal
[Fail Safe]: Fail safe function and battery fail safe function setting
[End Point (ATV)]: Servo basic rudder adjustment and limit setting
[Throttle Cut]: Stops the engine safely and easily (airplane and helicopter only)
[Idle Down]: Lowers the idle speed of the engine (airplane and helicopter only)
>6ZDVK 5LQJ@ /LPLWV WKH VZDVK WUDYHO ZLWKLQ D ¿[HG UDQJH WR SUHYHQW OLQNDJH GDPDJH KHOLFRSWHU RQO\
[Swash]: Swash AFR and linkage correction function (helicopter only)
[Timer]: Timer setting and lap time display
[Dial Monitor]: Dial, slider, and digital trim position display and setting.
[Function Name]: Function Name can be changed
[Telemetry]: Displays various data sent from the receiver.
[Sensor]: Various telemetry sensors setting
[Warning]: Warning sound and vibration setting.
[Data Reset]: Model memory data reset (by various item)
which model type you are using. A typical menu
screen is shown below.
5HWXUQ WR +RPH VFUHHQ
Condition Hold function ON/OFF button
The functions which can be selected depend on
<Linkage Menu> 69