FUTABA T18MZ Instruction Manual page 138

MODEL MENU (HELICOPTER)
This section contains information on the
commands that apply to helicopters only. For
instructions on Airplanes and Sailplanes, refer
to the sections pertaining to those aircraft. Each
of these functions can be set independently for
GLIIHUHQW ÀLJKW FRQGLWLRQV 7R JHW WR WKHVH VHWWLQJV
touch the desired function button to be entered.
Use the Model Type function in the Linkage
Menu to select the swash type matched to the
7RXFK WKH 0RGHO 0HQX EXWWRQ RI WKH +RPH VFUHHQ WR
FDOO WKH PHQX VKRZQ EHORZ 7RXFK WKH EXWWRQ RI WKH
IXQFWLRQ \RX ZDQW WR VHW WR FDOO WKH VHWXS VFUHHQ
Model Menu functions (helicopter) list
PIT Curve: $GMXVWV UHVSRQVH LQ GLIIHUHQW ÀLJKW FRQGLWLRQV
THR Curve: Throttle curve and hovering trim adjustment
Acceleration: Counteracts torque due to sudden throttle and pitch commands
Throttle Hold: Moves the throttle to idle during autorotation
Swash Mix: Compensates for each control response
Throttle Mix: Compensates for power loss when cyclic applied
Pit to Needle: $GMXVWV UHVSRQVH FXUYH LQ GLIIHUHQW ÀLJKW FRQGLWLRQV
Pit to RUD: Handles torque changes from pitch angle inputs
Fuel Mixture: Commands a second servo to adjust the fuel mixture at the carburetor
Gyro: Used to switch Futaba GY series gyro sensitivity
Governor: Used to switch RPM of the helicopter's head
Throttle Limiter: Limits the high range of the throttle movement by any slider or trimmer
138 <Model Menu (Helicopter Functions)>
5HWXUQ WR +RPH VFUHHQ
Condition Hold function ON/OFF button
)RU D GHWDLOHG GHVFULSWLRQ VHH 3 &RQGLWLRQ +ROG IXQFWLRQ 
fuselage beforehand. If you later change model
types, all settings will be lost.
Also, add flight conditions at the Condition
Select screen before setting the model data at each
function. (Up to 8 conditions can be used)
The AFR function, fuel mixture and other
functions common to all model types, are described
in a separate section.