Figure 6 Attach Middle And Upper Pole Assemblies - Tesoro Outlaw Operator's Instruction Manual

the upper pole assembly until the spring buttons
click into the holes, locking the two assemblies into
place. Tighten the pole lock to secure the two
assemblies together.
2. Choose the coil you're going to use. Remove one-
wrap Velcro strip from lower pole assembly.
Loosen the pole lock on the middle pole assembly.
Depress the first two spring buttons on the lower
pole assembly and slide lower pole into middle
pole, depress the second two spring buttons and
slide until spring buttons click into a set of
adjustment holes. Select the adjustment holes that
give you the proper overall pole length you require
(only one set of spring buttons will be in adjustment
holes depending on your length setting). Turn pole
lock to tighten, locking the assembly into place.
3. Wrap the cable around the pole leaving enough slack near the searchcoil to permit
searchcoil adjustment. (See Figure 8)
Note: Do not allow the cable to flop loosely over the searchcoil. Since the detector is sensitive
enough to "see" the tiny wires in the cable, a floppy cable can cause false signals as the
searchcoil senses the moving wires.
4. Plug the male cable end into the female connector
on the control housing and tighten the cable thumb
nut. You are finished!
Note: You will want to adjust the pole length and the
searchcoil angle to your preference. See
open in browser PRO version
Are you a developer? Try out the HTML to PDF API
Figure 6 – Attach Middle and Upper
Pole Assemblies
Field Use
pdfcrowd.com