Tesoro Outlaw Operator's Instruction Manual page 23

3. If the Threshold sound goes away when you lower the searchcoil, it will get louder as you
pull the searchcoil away from the ground. The Ground Balance is too negative. To
balance the detector, turn (see note below) the GROUND BAL knob clockwise (+
direction). "Pump" the detector again and repeat these steps.
NOTE: Start out using large turns of the GROUND BAL knob, ½ to ¼ of a full turn. Anytime the
Ground Balance goes from negative to positive or positive to negative, the proper Ground
Balance is between the previous setting and the current setting. Take much smaller steps until
the setting is as close to quiet as you can make it.
Important things to remember when Ground Balancing with
this method:
1. Make sure you are Ground Balancing in a clean area
and not lowering the searchcoil down over a piece of
metal.
2. When you pump the searchcoil, be sure that you DO
NOT tilt the searchcoil at an angle, as shown in Figure
13.
NOTE: As you move to different areas throughout the day, you
may need to make occasional small adjustments to the
GROUND BAL knob to maintain peak performance.
SELECTING THE PROPER OPERATING MODE
The Outlaw offer two operating modes: ALL-METAL and Discrimination (DISC) MODE.
open in browser PRO version
Are you a developer? Try out the HTML to PDF API
Figure 13 – Do Not Tilt the
Searchcoil at an Angle to the
Ground
pdfcrowd.com