Tesoro Outlaw Operator's Instruction Manual page 5

To install or replace the battery, first make sure the Sensitivity (SENS) control is set to OFF -
turned completely counterclockwise past the "click". Remove the battery door from the back of
the control housing. Do this by pressing your thumb firmly on the louvered square - at the
bottom of the battery door- and sliding the battery door upward (in the direction of the arrow)
while pushing.
Check the polarity on the battery and on the diagram inside the battery compartment. Make
sure they match when you insert the fresh 9 volt alkaline battery into the compartment.
Replace the battery door by sliding it into place making sure the upper mount slots are in line
and the lock tongue is snapped in place.
ATTACHING LOWER POLES TO THE COILS
1. On a lower pole assembly,
remove the mounting screw and
thumb nut from the black nylon
pole.
Leave the friction washers in the
recessed feature of the pole tip.
open in browser PRO version
Are you a developer? Try out the HTML to PDF API
Figure 2 – Removing Mounting Screw and Thumb
Nut
pdfcrowd.com