Table of Contents
Advertisement
Global Setup (cont.) - Turn-On Settings
Turn-On Volume Level Settings
The SSD-66 (5.1) has turn-setting that involve what volume level the SSD-66 (5.1) will turn on
to.
1 Last Volume Used - This setting will have the SSD-66 (5.1) engage the volume
settings that were last used before the unit was turned off.
2 Volume Preset - This setting will have the SSD-66 (5.1) engage the volume
preset that is programmed into the SSD-66 (5.1).
Please note, the SSD-66 (5.1) can be turned on by either pressing the OFF button twice. The
first time the OFF button is pressed, the SSD-66 (5.1) will mute. The second time it is pressed,
the SSD-66 (5.1) will turn off.
The SSD-66 (5.1) can also be turned off by unplugging the unit. While you will typically never
setup an SSD-66 (5.1) so that you will always unplug it, you may tie the SSD-66 (5.1) into a
switched AC outlet on some other type of control device such that whenever this secondary
device is turned off, the SSD-66 (5.1) will also turn off. As all parameters are programmed
into nonvolatile memory on the SSD-66 (5.1), the unit will retain all programming information,
even when it is unplugged.
To determine whether the SSD-66 (5.1) turns on to its last volume used or its programmed
volume preset:
1
Repeatedly press the SETUP MODE button until the SSD-66 (5.1)'s display reads
either "ON=LAST VOL" or "ON=PRE VOL". "ON=LAST VOL" refers to the SSD-
66 (5.1) turning on to its last volume used. "ON=PRE VOL" refers to the SSD-66
(5.1) turning on to its programmed preset volume.
2
Use the VOL UP or VOL DN buttons to alter the between these two options.
3
When the correct option appears in the SSD-66 (5.1)'s display window, press the
INPUT SELECT button exit the SSD-66 (5.1)'s program mode.
Determining the SSD-66 (5.1)'s Software Version Number
The SSD-66 (5.1) operates on a proprietary software program. As with all software, as im-
provements and new features are added to the preamplifier/decoder, software changes may
not be uncommon. These upgrades are not expensive and insure the on-going value of your
SSD-66 (5.1).
To determine the current software installed in your SSD-66 (5.1), simply remove power from
the unit. This can be easily accomplished by:
a
Simply unplugging the unit from the wall outlet and plugging it back in again.
b
Unplug the AC cord going into the SSD-66 (5.1) and plug it back in again.
c
Turn off a system power switch, which would remove power from the SSD-66 (5.1)
and turn it back on again.
When the SSD-66 (5.1) first receives power, its display will momentarily show the version
number.
- 34 -
Advertisement
Table of Contents
