Table of Contents
Advertisement
Using the Basic four source setup with slightly Different Source Components
While the basic four source setup (five sources if your CD player has an optical output) is
based on commonly used system sources, you may need to relabel an Input Name to corre-
spond to your system.
Example - What do I do if I don't have a Satellite or DSS but do have a Camcorder?
If your system does not have a Satellite or DSS receiver, yet you are including a Camcorder,
you could opt to connect the Camcorder to Analog Input 4 and Video Input 4 in place of the
Satellite receiver. If this is the case, you will want to relabel the "SATELLITE 4" Input Label
to read "CAMCORDER
number as found on the SSD-66 (5.1)'s remote control.
To Change the "SATELLITE" label to read "CAMCORDER", follow these steps.
Step 1
Repeatedly press the INPUT SELECT button until the SSD-66 (5.1)'s display reads
"SATELLITE 4".
Step 2
Repeatedly press the SETUP MODE button until the SSD-66 (5.1)'s display reads
"LABEL INPUTS". Please note, the SSD-66 (5.1) is designed to time-out automati-
cally from the "Setup Mode". If this should happen, the LED on the SETUP MODE
button will turn off. To pickup where you left off, press the SETUP MODE button
again.
Step 3
Press the "ALL" button to engage the character cursor. Please note, pressing and
holding the ALL button will cause the SSD-66 (5.1) to scroll through all Input Label
names without changing inputs. The words "LABEL INPUTS" will be replaced by
the Input Label currently selected, "SATELLITE". Furthermore, the "S" in "SATEL-
LITE" will begin to flash letting you know that this letter is ready to be changed.
Step 4
Use the RIGHT or LEFT button to scroll up and down (respectively) through alpha-
numeric characters, symbols, and numbers until the letter "C" replaces "S".
Step 5
Press the CENTER button to advance to the cursor to the next letter. Since the "A"
is used for CAMCORDER, press the CENTER button again so that the "T" is flash-
ing. Please note, if you pass a letter you wish to change, you can use the REAR
button to go back to it.
Step 6
Again, use the RIGHT or LEFT button to change the letter "T" to the letter "M".
Again, if you pass the correct letter in the character generator when pressing the
LEFT button, pressing the RIGHT button will scroll back to it.
Step 7
Repeat this process of using the CENTER button to move the cursor and the RIGHT
or LEFT buttons to change the letters until you spelled out "CAMCORDER".
Step 8
Press the INPUT SELECT button again. This will exit the "Setup Mode" and save
the changes to the Input Label.
At this point, you have made it easy for yourself to access the Camcorder. Naturally, this
same procedure can be used to alter any and all Input Labels. You can also change Input
Labels at any time, permitting you to constantly expand and add new sources.
4". Please note, the number "4" is fixed and refers to the input
- 11 -
Advertisement
Table of Contents
