Custom Setup - Turn-On Input - Ada PTM-6150 Operation & Installation Manual

Custom Setup - Turn-On Input

The Cinema Reference
provides you with the ability
to select which device you
want the Cinema Reference to
always turn on to. If you
primarily use the Cinema
Reference for viewing DSS
broadcasts, you will want to
alter the Turn On Input.
The Cinema Reference's "Out
Of The Box" Turn On Input is
set to VCR as most any home
theater system includes a
VCR. The steps in the
paragraph to the right detail
how to alter the Cinema
Reference's Turn On Input.
While you may opt to have the
Cinema Reference turn on to a
specific component, you may
also opt to have the Cinema
Reference always engage to
the input last used.
The Cinema Reference is factory set to always turn on to the VCR 4
input. Thus, even if you were watching a movie on DVD last night,
when the kids come to turn it on in the morning, the Cinema Refer-
ence will always switch to the VCR.
While this ideal for some, you may prefer to have your Cinema Ref-
erence to turn on to another device, for example the DSS receiver.
You may even prefer to have the Cinema Reference always engage
to the component that was last used. Any of these options is easy to
access by following these steps.
To alter the Cinema Reference's Turn-On Input:
1 Turn the MODE knob clockwise until the display reads SETUP
MODE and then press the MODE knob.
2 Turn the MODE knob clockwise to until the display reads
TURNON INPUT press the MODE knob.
3 Turn the MODE knob until the display reads the device you
wish to have the Cinema Reference come on to or to the
words LAST USED and press the MODE knob to engage
that setting.
4 If you wish to exit the setup mode, simply turn the INPUT
knob.
Page 41