Pc Cards - Panasonic CF-37 Series Reference Manual

PC Cards

Label-side up
Lever
Your computer has one PC Card slot. This slot conforms to the PC Card Standard;
therefore, communications and SCSI devices may be utilized. The slot allows you to
use one Type I or Type II card.
CAUTION
Check the PC Cards' specifications. Be sure the total operating current does not
exceed the specified limit. Damage may result otherwise.
Allowable Current : 3.3 V: 400 mA, 5 V: 400 mA
ZV card, SRAM card, FLASH ROM card (except for an ATA interface) and card
requiring 12 V are not supported.
Windows NT
CardBus type cards are also not supported.
Windows 2000
If the computer freezes after resuming from the standby or hibernation mode, try
removing and then reinserting the PC Card. If this does not correct the problem,
reboot the computer.
Installing/Removing the PC Card
Installing a PC Card
Simply slide the PC Card in until it snaps into place. Please refer to the
manual for each card on how to install the card (insertion is typically label-
side up).
CAUTION
When inserting a card, do not force the card in if difficulty is encoun-
tered. You may damage the slot, making it impossible to remove the
card.
Removing a PC Card
CAUTION
Do not remove a PC Card while your computer is in the standby or hiber-
nation mode.
Select
Follow the on-screen instructions.
(When removing a PC Card after turning off the computer, this step is
not need.)
Pull the lever out.
Slide the lever and slide the PC Card out.
Put the lever into place.
Windows 2000
( ) on the taskbar, then select [Stop].
38