Pc Cards - Panasonic Toughbook CF-M34 Series Reference Manual

PC Cards

Label-side up
Button
Your computer has one PC Card slot. This slot conforms to the PC Card Standard;
therefore, communications and SCSI devices may be utilized. The slot allows you to
use one Type I or Type II card.
CAUTION
Check the PC Cards' specifications. Be sure the total operating current does
not exceed the specified limit. Damage may result otherwise.
Allowable Current : 3.3 V: 400 mA, 5 V: 400 mA
ZV card, SRAM card, FLASH ROM card (except for an ATA interface), CardBus
card and card requiring 12 V are not supported.
When removing a network card, be sure the power has been turned off be-
fore proceeding.
Installing/Removing the PC Card
Installing a PC Card
Open the cover
Simply slide the PC Card in until it snaps into place. Refer to the
manual for each card on how to install the card (insertion is typically
label-side up).
CAUTION
When inserting a card, do not force the card in if difficulty is en-
countered. You may damage the slot, making it impossible to re-
move the card.
In the case of a PC Card to connect a peripheral device (SCSI,
IEEE 1394, etc.), first connect the peripheral device to the card,
and then insert the card after switching on the device.
Removing a PC Card
CAUTION
Do not remove a PC Card while your computer is in the suspend or
hibernation mode.
Press the button out, and then press the button again.
Slide the PC Card out.
22