Panasonic CF-37 Series Reference Manual page 11

Touchscreen
Devices
Configure the device controller.
Hardware
Set the hardware resources.
Match this setting with the
setting for [Base I/O] in the
Setup Utility.
Settings
Set the general protocol
settings.
Configuring the Touchscreen
When needed, the touchscreen can be configured using the following steps.
1
Select from the taskbar or select [Settings] from [Start] -
[Programs] - [Updd]
The following screen will appear.
Windows
Set the "double-click"
settings.
Advanced
Set the advanced settings.
NOTE
The touchscreen can be used for only [Whole Desktop] setting in [Devices] -
[Modify] - [logical desktop segment]. This setting is default.
2
Make necessary changes
3
Select [OK]
NOTE
It is also possible to change the double-click speed in [Buttons] for [Start] -
[Settings] - [Control Panel] - [Mouse]. However, when [Double Click Speed]
in [Mouse] is changed, the double click time in [Windows] is also changed. In
addition, the setting becomes the setting for [Buttons] in [Mouse] after the
computer is restarted or enters the standby or hibernation mode.
Immediately run [Calibrate] when the number of points of calibration is
changed.
Calibration
Define the calibration setup. Use this procedure when the
cursor, the stylus (included) and your finger touches do not
appear to agree. (Necessary for changes in the alignment
of the touchscreen with visual images or an adjustment of
the display resolution.)
Touch the "+" mark on the calibration screen for about one
second.
After the calibration procedure is executed (e.g., after the
nine "+" marks are touched), the procedure ends when the
Enter is pressed.
Status
Display the status of the controller.
About
Display the version number.
Button Modes
Set the button modes.
General
Set the general settings and func-
tions.
Events
Set the events that can be generated
by a controller.
NOTE
For more information, refer to [Help].
11
page 8