Table of Contents
Advertisement
Enable scanner ID report
Disable scanner ID
report
Set Tab between ID and
barcode
Set White Space between
ID and barcode
Set "-" between ID and
barcode
Restore all original
receiver settings
Save & Exit
Note: After a programming operation, the reader will emit beeps and the light
will flash to indicate association to the base. Put the reader close to the base.
Unplug the base for a few seconds then plug it back. The light and the beeper
will stop on a successful setting. Then the reader will perform on the new setting.
Repeated code detection setting
Setting code
Enable repeated code
detection
Display scanner ID at the
receiving end.
Do not display scanner ID at
the receiving end.
Set the delimiter between ID
and barcode a Tab when ID
report is enabled. (Default
setting)
Set the delimiter between ID
and barcode white space when
ID report is enabled.
Set the delimiter between ID
and barcode a "-" when ID
report is enabled.
Restore this module to original
settings.
Function
Enable
repeated
code detection.
Note: this setting
will
be
automatically saved
and
remain
effective
after
power failure.
8
e.g.:
ID=10, barcode=
12345; display: 10
12345
e.g.:
ID=10, barcode=
12345; display: 10
12345
e.g.:
ID=10, barcode=
12345;
10- 12345
Description
When this function
is
activated,
the
scanner will give an
error alarm with 5
beeps
and
automatically
cancel
the
last
repeated code if a
repeated
code
is
scanner
scanner
scanner
display:
Hide quick links:
Advertisement
Table of Contents
