Netum NT-9600 User Manual page 11

The reader emits
a beam but does
not read bar
codes.
Troubleshooting the scanner (continued)
The reader does not emit
a beam and read bar
codes.
associated to the base,
storage mode will be
automatically
activated to replace
normal instant upload
mode.
Wireless scanning function
is not activated.
System is jammed.
The reader could
associate with the base.
The reader is
not receiving
power.
cards or 6
other hand, when instant uploading is
not needed, scan the storage mode code
below it to store scans.
Scan the code "start wireless scanning"
on the association cards or page 11 of
the guide book.
Scan the code "restore all original
scanner settings" at the right bottom on
page 11 and then scan the code "start
wireless scanning" below it.
1) scan the first code on page 8 "enter
setting";
2) scan the last second code on page 8
"restore
settings";
3) scan the last code on page 8 "save &
exit";
4) scan the first code on page 9 "enter
setting";
not 5) scan the last second code on page 9
"restore all original receiver settings"
(the reader will emit beeps);
6) put the reader close to the base;
remove the base cable and plug it back
after a few seconds; the flashing light
and beeper
successful; (if the beeper does not stop
after you remove the base cable, repeat
the above steps.)
7) scan the last code on page 9 "save &
exit".
Make sure the battery pack is fully
charged. Replace the battery pack if
damaged.
11
th
page of this book. On the
all original transmitter
will stop; setting is