Table of Contents
Advertisement
NOTE
If only one handset is registered the display prompts "Not
available" and returns to the previous screen. You must register
additional handsets before the handsets will be displayed and
make Internal calls.
NOTE
If the Room Monitor is triggered to call a handset or number and
the called handset is on a call, an alert tone of 3 beeps will be
heard. If the Room Monitor is triggered continuously the alert
beap will be emiitted every 5 seconds.
WARNING
This product is not intended for use as a baby safety device and
is not a substitute for adult supervision.
Using additional handsets
12. Using additional handsets
You can use up to five D11P additional handsets with your
D11P base to extend your phone system without needing to
install extension sockets for each new phone.
Your D11P handset can also be registered to up to 3 other
bases. You can then select the base you would prefer to use.
If you have purchased a D11P multiple pack any additional
handsets come pre-registered to the base.
If you have purchased an additional handset separately you
must register it to your D11P base before it can be used.
Registering an additional handset
At the base:
p
1. Press and hold
for 2 seconds until the base Power
starts flashing. The base will remain in registration mode for
90 seconds.
At the handset:
1. If the handset is new and the display shows
u
Menu
Registration
Press
. Scroll
to
. Press
Or
If the handset has already been registered to another base
Menu
the standby display is shown. Press
Registration
Select
and press
.
Register Handset
Select
2.
is highlighted. Press
3. Bases are displayed. If necessary, scroll
base you wish to register your D11P handset to and press
Select
.
OK
4. Enter the system PIN and press
. (Default setting =
0000)
Searching Base X
5. The display shows
(where X is the chosen
Handset Registered
base number) then
.
The handset is automatically assigned the next available
handset number.
If registration is not successful first time, please repeat the
process again in case the base registration period ran out of
time.
If there are already 5 handsets registered to the base, the
registration will fail. You must de-register another handset before
you can register the new one.
Select a base
If your D11P handset is registered to more than one base, you
can select which base to use.
Menu
1. Press
, scroll
d
Select Base
2. Scroll
to
3. All base numbers are displayed.
where the handset was previously registered to. Scroll
d
to the base you want and press
Searching Base...
4. Display shows
that base.
De-register a handset
Use one handset to de-register another. You cannot de-register
the handset you are using.
Menu
1. Press
, scroll
d
De-register
2. Scroll
to
3. Enter the system PIN and press
0000)
u
d
4. Scroll
or
to the handset you want to de-register and
Please Register
.
Select
press
.
Select
.
Yes
5. Press
to confirm or
Back
6. Press
to return to the previous menu level or
return to standby.
u
d
, scroll
or
to
.
u
d
or
to a new
u
d
Registration
Select
or
to
and press
.
Select
and press
.
(In use)
is added to bases
u
or
Select
.
. then the standby display for
u
d
Registration
Select
or
to
and press
.
Select
and press
.
OK
. (Default setting =
No
to cancel.
>
to
17
Advertisement
Table of Contents
