Sequence Of Operation; Shelded Metal Arc Welding (Smaw); Gas Metal Arc Welding (Gmaw) - Thermal Arc TA-8/300-KAT Instruction Manual

18. SEQUENCE OF OPERATION

WARNING : Read and follow all safety precaution before proceding with operation.
18.01

SHELDED METAL ARC WELDING (SMAW)

1. Install and connect unit according to the installation section.
2. Wear gloves and clothing.
3. Connect work clamp at workplace.
4. Select power electrode.
5. Place the selector switch in STICK position.
6. Place the OUTPUT CONTACTOR switch in ON position.
7. If remote amperage control is not used, place the Amperage/Voltage switch in panel position.
8. Rotate the Amperage/Voltage control, to desired position.
9. Insert electrode into electrode holder.
18.02

GAS METAL ARC WELDING (GMAW)

1. Install and connect unit.
2. Install and connect wire feed system.
3. Wear gloves and clothing.
4. Connect work clamp at workplace.
5. Place the process selector switch in MIG position.
6. Place the Amperage/Voltage switch in desired position.
7. Rotate Amperage/Voltage control to desired position.
8. Turn on shielding gas supply and set desired flow rate.
9. Place the Primary Power switch in ON position.
10. Begin welding.
30