Switching The Warning Tone; Switching The Auxiliary Setting; Setting The Rear Output And Subwoofer Output - Pioneer DEH-P6100BT Operation Manual

Qnitial Settings
Section
• If 30 to 59. the minutes are rounded up.
(e.g. 10:36 becomes 11:00.)
4 Push MUlTI-CONTROL up or down to
put a clock right.
[OJ
Switching the warning tone
If the front panel is not detached from the
heed unIt withlii four seconds of turning off
the Ignition. a warning tone sounds. You C{'In
turn off the warning tone.
1 Display the initial setting menu.
Refer to Adjusting india! settings on the pre·
VIOUS
page.
2 Use MULTI-CONTROL to select
WARNING
in the initial setting menu.
3 Press MULTI-CONTROL to turn warning
tone on.
• To tum warning tone off,
pt"ess
MULTI-CONTROL aga," ~J
Switching the auxiliary setting
Auxiliary devices connected to this unit can be
act vated individually. Set each AUX soulce to
ON when using. For rnore information about
connecting or using auxiliary devices. refer to
USing the AUX source on page 45.
1 Display the initial setting menu.
Refer to Adjusting Imflal settings on the pre·
VIOUS page.
2 Use MULTI-CONTROL to select AUX11
AUX2.
3 Press MULTI-CONTROL to turn AUXlI
AUX2 on.
• To turn AUX ot!. press MULTI·CONTROL
again.0
Setting the rear output and
subwoofer output
This unit's rear output (rear speaker leads out-
put
and RCA rear output) can be used for full-
range speaker (Rear SP :REAR) or subwoofer
(Rear SP :SUB
W)
connect,on If you SWitch
the rear output setting to Rear SP :SUB W. you
can connect a rear speaker' lead directly to a
subwoofef without using an auxiliary amp,
Initially. the unit is set fo( rear full-range speak-
er connection (Rear SP :REAR).
1 Display the initial setting menu.
Refer
to Adjustmg mltial settings
011
the pre"
VIOUS
page.
2 Use MULTI-CONTROL to select REAR SP
in the initial setting menu.
3 Press MULTI-CONTROL to switch the
rear output setting.
Pressing MULTI-CONTROL will sw,tch be-
tween Rear SP :REAR (tull-range speaker) and
Rear SP :SUB
W
(subwooter) and that slat us
will be displayed.
• When no subwoofer IS connected to the rear
output. seiect
Rear
SP
:REAR
(full-range speaker).
• When a subwoofer is connected to the rear
output. select
Rear SP :SUB W
(subwoofer).
UNotes
• Even If you change this setting, there IS no
output unless you tum the subwoofer output
on (refer to
Usmg subwoo!eroutput
on page
401
• If you change thiS setting. subwoofer output
in the audio menu Will retum
to
the factory
settings.
• Both rear speaker lead outputs and RCA rear"
output at'e SWitched simultaneously in thiS
setting.8
m
~
CO
III
:r
En
@)