Initial Settings; Adjusting Initial Settings; Setting The Fm Tuning Step; Switching Auto Pi Seek - Pioneer DEH-P77MP Operation Manual

Initial Settings

Adjusting initial settings

1
Initial settings lets you perform initial set up of
different settings for this unit.
1 Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press FUNCTION and hold until function
name appears in the display.
3 Press FUNCTION to select one of the in-
itial settings.
Press FUNCTION repeatedly to switch be-
tween the following settings:
FM STEP (FM tuning step)AUTO PI (auto PI
seek)WARNING (warning tone)AUX (aux-
iliary input)DIMMER (dimmer)REAR SP
(rear output and subwoofer controller)TEL
(telephone muting/attenuation)
Use the following instructions to operate each
particular setting.
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down FUNCTION until the unit turns off.

Setting the FM tuning step

Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
All manuals and user guides at all-guides.com
1 Press FUNCTION to select FM STEP.
Press FUNCTION repeatedly until FM STEP ap-
pears in the display.
2 Rotate ROTARY ENCODER to select the
FM tuning step.
Rotate ROTARY ENCODER will switch the FM
tuning step between 50 kHz and 100 kHz while
AF or TA is on. The selected FM tuning step
will appear in the display.
Note
The tuning step remains at 50 kHz during manual
tuning.

Switching Auto PI Seek

The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1 Press FUNCTION to select AUTO PI.
Press FUNCTION repeatedly until AUTO PI ap-
pears in the display.
2 Press ROTARY ENCODER to turn
AUTO PI on or off.
Pressing ROTARY ENCODER repeatedly will
turn AUTO PI on or off and that status will be
displayed (e.g., AUTO PI:ON).

Switching the warning tone

If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1 Press FUNCTION to select WARNING.
Press FUNCTION repeatedly until WARNING
appears in the display.
Section
12
43
En