Attaching The Front Panel; Reselling The Microprocessor; Use And Care Of The Remote Control; Installing The Balter) - Pioneer DEH-P6100BT Operation Manual

Section
lID (
Before You Start
3
Put the front panel into the provided
protective case for safe keeping.
Attaching the front panel
1
Slide the front panel to the left until it
dicks.
Front panel and the head unit are jointed on
the left Side. Make sure that the tront panel
has been jointed to the head unit.
2 Press the right side of the front panel
until it is firmly seated.
• If you can't attach the front panel to the head
unit successfully, try again. Front panel may be
damaged if you attach the front panel forcedly.
Resetting the microprocessor
The microprocessor must be reset under the
following conditions:
• Prior to using this unit for the first time
after installatron
• If the unit fails to operate properly
• When strange or incorrect messages ap·
pear on the display
1 Remove the front panel.
Refer to Removing the front panel on the pre·
VIOUS
page.
CD
En
)
2 Press RESET with a pen tip or other
pointed instrument.
RESET button
Use and care of the remote
control
Installing the battery
Slide the tray on the back of the remote con-
trol out and insert the battery with the plus (+)
and minus H poles aligned properly.
6WARNING
• Keep the battery out of the reach of children.
Should the battery be swallowed, consult a
doctor immediately,
• Batteries (battery pack or batteries installed)
shall not be exposed to excessive heat such
as sunshine, fire or the like.
6
CAUTION
• Use one CR2025 13Y) lithium battery.
• Remove the battery if the remote control is not
used for a month or longer.
• There is a danger of explosion if the battery is
incorrectly replaced. Replace only with the
same or equivalent type.
• Do not handle the battery with metallic tools
• Do not store the battery with metallic objects.
• If the battery leaks, wipe the remote control
completely clean and install a new battery.