Toshiba UE3G2L036C61T Instruction Manual page 37

Display Screens (cont'd)
Data Setting Screen
The following screens show the setting procedure for setting the data variables. They are accessed
from the main 'data setting screens' (see page 30) when the
TO BEGIN:SET
OR
BATTERY TEST
INHIBIT
VOLTAGE ADJ: +5
TO ACCEPT: SET
VOLTAGE ADJ: +0
TO ACCEPT: SET
VOLTAGE ADJ: -5
TO ACCEPT: SET
Loops through three
possibilities
CLEAR TIMER SET
TO ACCEPT: SET
DEFAULT SETTINGS
TO ACCEPT: SET
TOSHIBA
BATTERY TEST
Shift
Set
+
Monitor
Select
Executes battery
test and returns
to Data Settings
Screens
Shift
Set
VOLTAGE ADJ: +5
+
TO CHANGE: SELECT
Monitor
Select
Shift
Set
VOLTAGE ADJ: +0
+
TO CHAGNE:SELECT
Monitor
Select
Shift Set
VOLTAGE ADJ: -5
+
Monitor
TO CHANGE: SELECT
Select
Returns to Data Settings
Screens (with new value
applied)
CLEAR TIMER SET
Shift
Set
+
TO CHANGE:SELECT
Monitor
Select
Executes battery test
and returns to Data
Settings Screens
DEFAULT SETTINGS
Shift Set
+
TO CHANGE:SELECT
Monitor
Select
Executes battery test
and returns to Data
Settings Screens
38
key is pressed:
Shift
Select
This parameter has no options to set. A
battery test will be performed once the
SHIFT + SET button is pressed.
###%
If the BAT TEST INHIBIT message is
displayed, it indicated that a battery test
has been performed recently. The UPS
will not allow frequent battery tests to
insure that the batteries remain in a fully
charged state.
This parameter allows the user to offset
the output voltage (while the unit is
running on-line), by 1% increments
between -5% to +5%.
Default value is +0
This parameter has no options to set.
Pressing the SHIFT + SET button while
this message is displayed will cancel
timer setting.
This parameter has no options to set.
Pressing the select button while this
message is displayed will reset all
parameters to their default values.