Yellowtec iXm Operation Manual page 17

What happens
When you stop recording your iXm will transfer remaining audio to the
SD memory card. Please wait until this process is finished and the REC
LED stops flashing.
NOTE: Be aware that this can take a couple of seconds.
Never turn off the iXm before the red light stops flashing.
How can I monitor my
Connect a headphone to the green H/P output on the Port Panel.
NOTE: To provide a zero latency signal the H/P signal will
not be LEA processed. That is why your H/P signal may
sound distorted whilst your recorded signal will not be
affected!
Plug in your headphones and listen to your recording live. In order to
change the volume while listening, you can use the FWW and REW (6/3)
keys on the Playback Keypad in order to increase or decrease the H/P
volume.
Push to increase/decrease the volume in steps of 1 dB or hold the but-
ton to increase/decrease volume by 1 dB per second.
First you need to activate the option in the `Admin Software' . You need
headphones plugged into the HP/Out of the Port Panel in order to
monitor your recording.
How can I avoid to
recording?
For additional safety you can setup to end your recordings only by
double-pushing the STOP Key. (See chapter: Admin Software)
after the
accidentally stop my
www.yellowtec.com
Recording
recording?
recordings?
I info@yellowtec.com
17