Download
Share
Print this page
Yellowtec iXm Getting Started
  1. Manuals
  2. Brands
  3. Yellowtec Manuals
  4. Microphone
  5. iXm
  6. Getting started

Yellowtec iXm Getting Started

Hide thumbs Also See for iXm:
1
2
3
4
5
6

Advertisement

Quick Links

Download this manual
Getting Started
Congratulations to iXm, the powerful and easy to use reporter microphone with built-in
recorder. Before you start recording for the first time, you will need to charge the internal Li-
Ion accumulator battery to 100% capacity and to insert the SD card.
Preparation
Charging iXm
Connect the device to a USB-Port of your PC or an USB-Charger by plugging-in the USB
cable. iXm will indicate the charging process by a slowly yellow blinking BAT indicator. The
device need not be switched on.
When the BAT indicator stops blinking, the internal Li-Ion accumulator battery is full.
SD Memory Card
Insert the SD memory card into the device as shown on the picture below. Push it to the
bottom and release it. The card shall snap in.
If you want to remove the card, press it down again to release it.
iXm Getting Started. Yellowtec 10-2009.
Page 1 of 6

Advertisement

loading

Related Manuals for Yellowtec iXm

Summary of Contents for Yellowtec iXm

  • Page 1 Charging iXm Connect the device to a USB-Port of your PC or an USB-Charger by plugging-in the USB cable. iXm will indicate the charging process by a slowly yellow blinking BAT indicator. The device need not be switched on. When the BAT indicator stops blinking, the internal Li-Ion accumulator battery is full.

  • Page 2: Switch Off

    1 second. Record Keypad Playback Keypad iXm will start booting. The boot process is indicated by a fast green blinking REC indicator. When booting is completed, iXm will perform a memory check indicated by a fast red blinking MEM indicator.
  • Page 3 The device will indicate ready for record after the record file has been completed. iXm Getting Started. Yellowtec 10-2009. Page 3 of 6...
  • Page 4 In case you want to monitor record files, you will need to plug-in a headphone with 3.5mm jack into iXm s green HP socket. The playback keypad does allow for easy navigation through multiple audio files. Press PLAY to play back the lastly recorded file. Press STOP to end the playback.
  • Page 5 Press and hold FWD and STOP buttons on the playback keypad to enter iXm s setup mode indicated by a red MEM LED. This mode will be used for configuration of iXm or to obtain status information running admin and respectively user software that both belong to iXm s scope of delivery.

  • Page 6: Software & Driver

    The user software will connect with your device once you have selected the right COM port and pressed connect . The user software does not require a password. The admin software will require a password. The initial password for admin and superadmin is: qwe123asd iXm Getting Started. Yellowtec 10-2009. Page 6 of 6...