Table of Contents
Advertisement
FIGURE 4
Dimension "A" is to be a minimum of 3-inches (7.5 cm).
RECREATIONAL
VEHICLES
The installation of a rangedesignedfor recreational
Check the range modelnumber plate to see if the range is
vehiclesmust conformwith state or other codes or, in the
approvedfor installationin mobile homesand/or
absence of such codes,with the Standardfor
recreationalvehicles. If approvedthe followingitemsare
RecreationalVehicles,ANSI A119.2-latest edition.
applicable.
In Canada the rangemust be installedin accordance with
MOBILE HOMES
CAN/CSA - Z240.6.2 - ElectricalRequirementsfor R.V.'s
The installation of a range designedfor mobilehome
(CSA StandardCAN/CSA - Z240 RV Series) and Section
installationmustconform with the ManufacturedHome
Z240.4.2 - installationRequirements for Propane
Constructionand Safety Standard,Title 24 CFR, Part
Appliancesand Equipmentin R.V.'s (CSA Standard
3280 [formerlythe Federal Standardfor MobileHome
CAN/CSA - Z240 RV Series).
Construction and Safety, Title 24 HUD, (Part 280)] or,
when such standard is not applicable,the Standardfor
LOCATING THE RANGE
Manufactured Home installations,ANSI A225.1/NFPA
Do not set rangeover holesin the flooror other locations
501A, or with local codes,
where it may be subjectto strongdrafts.Any openingin
the wall behindthe rangeand in the floor underthe range
In Canada the range mustbe installedin accordancewith
shouldbe sealed. Make sure the flow of combustionor
the currentCSA StandardC22.1 - Canadian Electrical
ventilationair is not obstructed.
Code Part 1 and SectionZ240.4.1 - Installation
Requirementsfor Gas BurningAppliancesin Mobile
NOTE: A range should NOT be installedover kitchen
Homes (CSA Standard CAN/CSA - Z240MH).
carpeting.
-4 _
Advertisement
Table of Contents
