Jenn-Air 8181P367-60 Installation Manual page 14

PROPANE GAS (LP) TO NATURAL GAS CONVERSION INSTRUCTIONS
TO CONVERT APPLIANCE FOR USE WITH
NATURAL GAS
1. Replace all orifice hoods,.. Perform step 1
through 4 on pages 12 & 13, Locate the (4) four
Natural Gas hoods (with small numbersstamped on
their sides)saved from originalNatural Gas model. The
two hoodswith .0520 (#55 orifice)stamped on them
are for the left frontand left rear burners.The two
hoodswiththe .0595 (#53 orifice)stamped on them are
for the two right burners.
To make these conversion adjustments follow the
instructions and illustrations ("A" through "D") on
pages 13 and 14.
2, Invert cap in pressure regulator (see illustration
"A"). With the appliance installed, the regulator Is
located on the center underside of the appliance at the
inlet to the gas manifold. Identify the type of regulator
on the unit and follow the instructions in the appropriate
illustration.
Manifold - Natural Gas pressure required - 5" Water 3. Adjust low flame setting for each burner. Follow the
Column. instructionsfor burner low flame adjustment on page
14 to increase the simmer flame size.
Incoming Natural Gas pressure requiredto regulator - 6" -
7" Water Column. Natural Gas inputrequired - 36,000 BTU/hr.
INCHES
BURNER BTU/hr ORIFICE DIAMETER COLOR
Left Rear (LR) 8,000 #55 .0520 Brass
Left Front (LF) 8,000 #55 .0520 Brass
Right Rear (RR) 10,000 #53 .0595 Brass
Right Front (RF) 10,000 #53 .0595 Brass
-15-