Table of Contents
Advertisement
3. Make cutout in the cabinet floor of eitherthe right or
.._
,,LET __..
left side cabinet as shown in figures 14 or 15.
I.,,,.- 14.._,.. _'1
/
1
4. Relocate the mounting brackets on the blower
I m__
_'
housing as shown in figure 17.
NOTE: The mounting brackets shown in figure
_=,A-
-!
=LOIn
16 are as assembled at the factory for floor or
I
_2.?0
can)
-
_"rl@N
rear wall venting.
Figure 14
a. Right side venting (figure 17),
Left Cabinet (Top View)
1. Remove nutsfrom studs 1, 2 and 3 on the
motorside.
2. Remove bracket and reattach with studs 1 and
_
INI_
(_,_
_._'<l_"_l=..,,--
,)
2 inserted in holes A and C and replace 3 nuts.
)
3. side.Rein°re
nuts from studs 5, 6 and 7 on air inlet
,t-_--_
_ _
_1,1_
r-
jl
4, Remove bracket and reattach with studs 5 and
IL'+
_IIIIHI1
_('ZT_m)
6 inserted in holes D and B and replace 3 nuts.
,,#, I1_
'_o_"
- .......
==-====)
b. Left side venting (figure 17).
L_
!:
(_=_/'_:.%T--_._.,.,,,,,
'
1. Remove nuts from studs 1, 2, 3 and 4 on motor
side.
Figure 15
2. Remove bracket.
Right Cabinet (Top View)
3. Rotate motor and cover assembly 180 degrees.
4. Reattach bracket with studs 4 and 1 inserted in
holes A and C and replace all 4 nuts.
MOTORS I DE
A [ R INLET S IDE
5. Remove nuts from studs 5, 6, 7 and 8 on inlet
f
.__.
/
_
___.
_
side.
6. Remove bracket and reattach with studs 8 and
5 inserted in holes D and B and replace all 4
nuts.
5. Attach the blower housing to the floor with the outlet
towards the direction of the venting and the inlet
towards the front of the cabinets. In addition, for left
Figure 16
side venting, a spacer of approximately 1-1/2" thick x
9" long (3.81 cm x 22.86 cm) is required under the
Blower Assembly
mounting bracket flanges of the blower assembly (see
figure 17).
6. Remove the inside wire and outside string from the
Right Side
Left Side
first 1-1/2" (3.81 cm) of one end of the 5" (12.7 cm)
Venting
Venting
flex duct (PIN 702935). Stretch this end of the flex
duct over the end of the 5" x 3-1/4" x 10" (12.7 cm x
__._--'_
_
._"x
25.4 cm) transition and secure with hose clamp (P/N
702331).
7. When the range is placed in position, feed the open
end of the 5" (12.7 cm) flex duct through the hole in
the cabinet side wall and attach to the outlet of the
blower housing with hose clamp (PIN 702331). The
transition should then be attached to the 3-1/4" x 10"
SPacer/
(12.7 cmx 25.4 cm) ducting in the cabinet toe space
Figure 17
through the cabinet floor cutout.
View from Air Inlet Side of Blower
-9-
Advertisement
Table of Contents
