Table of Contents
Advertisement
BURNER CAPS AND SEALED
HOW TO REMOVE RANGE FOR
GAS BURNERS
CLEANING AND SERVICING
$ Allow burner to cool. Remove burner cap and wash in
Follow these procedures to remove appliance for
soapywater with a plasticscouringpad or in the
cleaning or servicing:
dishwasher.For stubbornsoils,clean with a soap-filled,
1. Shut off gas supplyto appliance.
nonabrasivepad or CooktopCleaningCreme (Part
#20000001).
2. Disconnectelectrical supply to appliance, if equipped.
S For burned on soil, place burner cap on newspaper and
3. Disconnect gas supply tubing to appliance.
spray with commercial oven cleaner. Follow
4. Slide range forward to disengage range from the
manufacturer's directions,
anti-tip bracket. (See page 5).
$ Clean gas ports with a straight pin especially the port
5. Reverse procedure to reinstall. If gas line has been
below the ignitor. Do not enlarge or distort holes,
disconnected, check for gas leaks after reconnection.
$ Be careful not to get water into burner ports.
NOTE: A qualified servicer should disconnect and
$ When cleaning, use care to prevent damage to the
reconnect the gas supply.
ignitor. If the ignitor is soiled, wet or damaged the
6. To prevent range from accidentally tipping, range must
surface burner will not light,
be secured to the floor by sliding rear leveling leg into
the anti-tip bracket.
-16-
Advertisement
Table of Contents
