Radio Operations - Magnadyne RV5060 Operation And Installation Manual

RV5060-UM Rev. A

Radio Operations

Power On/Off:
Press the POWER button to turn the unit 0n.
Selecting the Play Source:
Press the MODE button until "RADIO" appears in the display. After a brief moment either AM or FM will
appear in the display.
Selecting the AM or FM:
Press the BAND button repeatedly and select
from 1 FM, 2 FM, 3 FM, 1 AM or 2 AM.
Manually Tuning in a Radio Station:
Press the l button to tune in a lower radio
station. Press the
higher radio station.
Note: The unit will automatically switch from FM
Mono to FM Stereo when the signal strength
increases to a stereo level. If the stereo signal
should become weak, the unit will switch back to
Mono. FM stereo reception is indicated when the
STEREO LED is lit.
Tuning in a Radio Station Using Seek:
Press the SEEK button and the tuner will scan up
to the next strong station and stop seeking, then
start playing.
Tuning in a Radio Station Using Scan:
Press the SCAN button and the tuner will scan
up to the next strong station and pause for 6
seconds, then scan for the next strong station.
To cancel this function press the SCAN button
again.
5/12/10 9:18 AM
l button to tune in a
Page 11
Radio Station Recall Buttons
Radio Station Recall Buttons
Radio Station Recall Buttons
Radio Station Recall Buttons
HEADPHONE
OUTPUT
HEADPHONE
OUTPUT
RESET
RESET
HEADPHONE
OUTPUT
RESET
HEADPHONE
OUTPUT
RESET
HEADPHONE
OUTPUT
RESET
HEADPHONE
OUTPUT
RESET
HEADPHONE
OUTPUT
RESET
HEADPHONE
OUTPUT
RESET
Lower
HEADPHONE
OUTPUT
HEADPHONE
OUTPUT
RESET
HEADPHONE
OUTPUT
RESET
Higher
RESET
HEADPHONE
OUTPUT
RESET
Lower
Lower
Lower
HEADPHONE
OUTPUT
RESET
HEADPHONE
OUTPUT
Higher
RESET
Higher
HEADPHONE
OUTPUT
HEADPHONE
OUTPUT
RESET
RESET
Higher
HEADPHONE
OUTPUT
HEADPHONE
OUTPUT
HEADPHONE RESET
OUTPUT
RESET
RESET
HEADPHONE
OUTPUT
RESET
HEADPHONE
HEADPHONE OUTPUT
OUTPUT
RESET
HEADPHONE
RESET
OUTPUT
RESET
HEADPHONE
OUTPUT
RESET
11
HEADPHONE
OUTPUT
HEADPHONE
OUTPUT
RESET
RESET
HEADPHONE
OUTPUT
RESET
HEADPHONE
OUTPUT
RESET