RV5060-UM Rev. A
Reset Button
The LCD display may fail to function normally due to the vehicle's battery condition, and could require
resetting the radio microprocessor if:
• The vehicle has been "jump started" from a dead battery condition.
• The vehicle battery becomes very low and is quick-charged.
• The vehicle battery is removed and replaced.
Should any of these conditions occur, simply press and release the RESET button on the radio front
panel using the tip of a ball point pen. This will reset the radio microprocessor to the original factory
settings. After pressing the RESET button you should recheck to see if the radio functions normally.
26
5/12/10
9:18 AM
Page 26