Fortress Technologies FSAV10M14 User Manual page 5

Air flow direction control
Adjust the air flow direction properly. Otherwise
might cause discomfort or cause uneven room
temperatures.
Adjust the horizontal/vertical louver using the remote
control.
To set the horizontal/vertical air flow direction
Perform this function while the unit is in operation.
Range
(Horizontal louver) Use the remote control to adjust the air flow direction.
The vertical/horizontal louver changes approximately 6
degree in angle for each press, the louver can also be set
to swing up, down, left and right automatically.
Please refer to the Remote Control User Manual
for details.
IMPORTANT: Do not put your fingers into the panel of
blower and suction side. The high-speed fan inside may
Range
cause danger.
(Vertical louver)
CAUTION
Do not operate the air conditioner for long periods with
the air flow direction set downward in COOL or DRY
mode. Otherwise, condensation may occur on the
surface of the horizontal louver causing moisture to
drop on to the floor or on furnishings.
When the air conditioner is switched on immediately
after it was stopped, the horizontal louver might not
move for approximately 10 seconds.
Open angle of the horizontal louver should not be set
too small, as COOLING or HEATING performance may
be impaired due to too restricted air flow area.
Do not move the horizontal louver manually. Otherwise
the horizontal louver will be out of sync. Please cease
operating, unplug the power for a few seconds, and
restart the air conditioner.
Do not operate the unit with the horizontal louver in
closed position.
7 7
How the air conditioner works
it
SLEEP operation
Set
Temperature
1 hour
Cooling
SLEEP operation
Set
Temperature
1 hour 1 hour
Heating
AUTO mode
7 hours timer off
When you set the air conditioner in AUTO mode, it will
automatically select cooling, heating or fan mode
operation depending on the temperature you have
selected and the room temperature.
The air conditioner will control room temperature
1 hour
5 hours automatically around the temperature point set by you.
If the AUTO mode is uncomfortable, you can set
desired temperature manually.
SLEEP mode
When you press SLEEP button on the remote control
7 hours timer off
during cooling, heating or AUTO operation , the air
conditioner will automatically increase (cooling) or
decrease (heating)
hold steadily for the next 5 hours, and switch off
afterwards.
This mode saves energy and brings comfort at night.
5 hours
DRY mode
The fan speed will be automatically controlled under the
dry mode.
During the dry mode, if the room temperature is
O
lower than 10 C, the compressor will stop operation
and restart until the room temperature is above
O
12 C.
8 8
per hour for the first 2 hours, then