To Create Vluns On The Sun Storedge 6900 For Windows Nt And Windows 2000 - Sun Microsystems StorEdge 3900 Series Reference Manual

4. Use this channel/WWN combination to create HBA aliases and SLIC zones on the
Sun StorEdge 6900 series.
Run the command showvemap on the Storage Service Processor, for example:
# /opt/SUNWsecfg/bin/showvemap -n [v1,v2] -f
5. Run the runsecfg(1M) command, for example:
# /opt/SUNWsecfg/bin/runsecfg
6. Select the Virtualization Engine Configuration Utility option and then the Manage
Virtualization Engine Zones option to set up a SLIC zone for each HBA.
Note – This is only a single zone and not a dual path with two zones.
To Create VLUNs on the Sun StorEdge 6900 for Windows
NT and Windows 2000
1. Get the virtualization engine pair name using the listvemap(1M) command, for
example:
# /opt/SUNWsecfg/bin/listvemap -r
v1
#
If no virtualization engine names are returned, either the virtualization engine is not
functioning or there is already an active configuration process.
2. Get the name of the Sun StorEdge T3+ array disk pool using the listvemap(1M)
command, for example:
# /opt/SUNWsecfg/bin/listvemap -d -n v1
t3b00 t3b01
#
In this example, the disk pool name would be t3b00.
Chapter 12 Connecting to Servers Running NT 145