Inserting And Removing The Sprint Pcs Connection Card - Novatel Merlin S620 User Manual

4.
When the firmware update is completed, it will reset the card.
Please wait a few minutes to initialize the Merlin S60 card from the
Sprint PCS network. If the card has not been activated, it will
automatically launch the Sprint PCS Vision Activation Wizard.
Note:
During this time, the Sprint PCS Connection Manager message area
displays "Updating Hardware"and the Go button is disabled.
Once the card is provisioned successfully, it will start IOTA (Internet
Over-the-Air) Activation to update your user profile from the Sprint PCS
network settings. If the card is not provisioned or out of Sprint 3G
service coverage, the Sprint PCS Vision User Interface will display "Sprint
PCS Vision: Searching for service...".
Inserting and Removing the Sprint PCS
Connection Card
Inserting the Sprint PCS Connection Card
Before you insert the Sprint PCS Connection Card, you must first install
the Sprint PCS Connection Manager Software (see page 14 in this
section). Once you have completed the software installation procedure,
you may insert your card into your computer's PC Card slot. The Sprint
label should be facing up and the 68-pin connector, located at the end of
the card, should be inserted directly into the computer's PC Card slot.
Note:
The Sprint PCS Connection Card should fit snugly, but you should be able
to insert or remove it easily from your computer's PC Card slot.
A portion (the black section) of the card will remain outside the PC Card
slot. This section contains the card's antenna and the LED (light emitting
diode). Because the card is not entirely contained in your computer's PC
Card slot, it is important to remove the card when transporting your
notebook or Tablet PC.
2A: Installing the Sprint PCS Connection Card 17