Table of Contents
Advertisement
7.0
FIXING THE APPLIANCE
After having selected the final mounting position of
the appliance, taking into account the site require-
ments as specified in section 4 of these instructions,
the integrity of the wall, and the feasibility of the
proposed supply pipe routing, the firebox of appli-
ance may be secured to the wall. A fitting template
is supplied to assist with this.
Mark the positions shown as "Gas model L23G" on
the wall. If the appliance is to be mounted on the
inner leaf of a conventional cavity wall, or a solid
wall, drill four holes using a 7mm masonry bit.
Insert the fibre wallplugs provided.
If the appliance is to be mounted on a dry lined wall or a timber framed construction wall then special cav-
ity screw fixings will be required which are not supplied with this product. These should be constructed
from metal and not plastic.
If a concealed gas connection is to be made ensure the gas
supply pipe is in it's final position and can enter the appliance
in the correct position when the appliance is hung on the wall.
Insert the wall fixing screws into the top wall plugs, taking care
to leave the screws protruding approximately 5mm from the
wall. Now hang the appliance onto these screws through the
two keyhole shaped holes in the back panel of the appliance.
Insert the lower fixing screws into the lower wall plugs through
the corresponding fixing holes in the lower part of the back
panel. Do not tighten fully.
Before tightening the wall mounting screws fully, at this stage
it is recommended to check the horizontal alignment of the
appliance with a spirit level, as small adjustments can still be
made if necessary. When this has been checked, tighten all four
fixing screws fully.
To access the upper fixing screws insert a screwdriver either
through the round holes in the front of the outlet grille, or
alternatively for easier access the outlet grille may be removed
and the fixing screws accessed more directly through the holes
in the deflector baffle as shown above.
CHECKING THE BURNER
7.1
There are no imitation fuel bed components to install. The appliance features a ribbon burner which is
designed to produce a continuous band of flame over it's length.
The burner should be visually inspected to ensure it is free from any foreign matter.
If it is necessary to clean or dust off the burner then the glass door should be removed by removal of the
four retaining screws. Re-fit the glass door after cleaning or inspection, ensuring a good seal.
5
Advertisement
Table of Contents
