Table of Contents
Advertisement
USER INSTRUCTIONS
Section
1.0
2.0
3.0
4.0
5.0
6.0
7.0
8.0
1.0
IMPORTANT NOTES
The installation and Servicing of this fire MUST only be carried out by a competent person (such as a
CORGI registered fitter) in accordance with the Gas Safety (Installation and Use) Regulations 1998, the
relevant British Standards, Codes of Practice, the Building Regulations and the manufacturer's instruc-
tions.
Failure to comply with the above recommendations could lead to prosecution and invalidate the appliance
warranty.
Always keep a note of the installer's name and address, CORGI registration number, the original purchase
receipt and the date of installation for future reference. Failure to produce these documents may invali-
date the warranty.
The appliance should be serviced regularly to ensure continued safe operation. See the servicing section
for further reference.
Parts of this appliance become naturally hot during use. It is recommended that a suitable fireguard
conforming to BS 8423 : 2002 is used, especially where young children, pets, the elderly or infirm are
concerned.
The manufacturer of this appliance considers all surfaces as working surfaces with the exception of the
control knob and indicator bracket.
Combustible items, such as flooring and furniture and soft wall coverings (such as blown vinyl or
embossed paper), low temperature surrounds etc may discolour if fitted too close to the fire. See rele-
vant section for further details on clearances to combustibles. No combustible materials or flooring
should protrude onto the hearth (if fitted).
This appliance incorporates a combustion monitoring system (ODS).
DO NOT burn any foreign material on this fire. Under no circumstances shall the appliance be used if the
glass front door or panel has been removed, damaged or is open.
DO NOT burn any foreign material on this fire. Under no circumstances shall the appliance be used if the
glass front door or panel has been removed, damaged or is open.
The integral catalysts should be checked by the installer upon servicing to ensure there are no defects or
obstructions that may prevent the satisfactory flow of combustion products.
The expected life of the catalyst is in excess of 11,000 hours (10 years of normal use). After this time the
catalyst should be replaced.
This appliance is only suitable for the gas type for which it is supplied.
It should be noted that heaters create warm air currents. These currents move heat to wall surfaces next to
the heater. Installing the heater next to vinyl or cloth wall coverings or operating the heater where impuri-
ties in the air (such as tobacco smoke) exist, may discolour walls.
WARNING: Due to the nature of this product the area around the top of the appliance (i.e. the grille) gets
very hot. Care should be taken when operating the appliance.
Content
Important Notes
Clearances to Combustibles
Ventilation & Room Size
Operating Instructions
Combustion Monitoring System
Cleaning
Servicing
List of Replacement Parts
1
Page No
1
2
2
3
3
3
3
3
Advertisement
Table of Contents
