Sanyo PDG-DWL100 Service Manual page 53

4. Click "Library".
- Click the "Browse" and navigate to
the directory where you put the DLP
Composer installation files in.
- Click "Library v8.3" folder.
- Click "OK".
5. Click "Communications".
- Select "Serial Port".
- Select the COM Port which you are using.
- Click "Configure".
6. "Serial Port Configuration" picture will
appear on the screen.
- Make sure the settings are as below:
(1) In "Baud Rate" item, select "115200".
(2) In "Data Bits" item, select "8".
(3) In "Stop Bits" item, select "1".
(4) In "Parity" item, select "None".
(5) In "RTS" item, select "Enable".
(6) In "CTS" item, select "Disable".
(7) Key in "6000" into "Read" and "Write"
items of "Timeouts (in milliseconds)".
- Click "OK".
7. Click "OK".
PDG-DWL100 Confidential
5-5