Removal Procedures; Attraction Roller Drive Assembly - Lexmark Optra C Service Manual

Removal Procedures

The removals in this section are arranged in alphabetical order.
To install parts, reverse the removal procedure, giving attention to
any special conditions listed.
When reinstalling the drive gear solenoid assembly removed in step
9, rotate the main drive motor (M2) counterclockwise after installing
the 4 screws. This ensures that all the gears latch up. Rotate the
motor until all the gears latch up and the motor turns freely.

Attraction Roller Drive Assembly

For cover removals, see "Cover Removals" on page 4-8.
1. Remove the top cover
2. Remove the left side cover.
3. Remove the rear cover.
4. Remove the EMC shield from the rear of the machine.
5. Open the multipurpose paper pickup door.
6. Release the two green cassette latches and slide the tray out as
far as possible.
7. Remove the connector cover (Asm 8-24) and disconnect the
connector.
8. Remove the LVPS.
9. Disconnect connector (J2014) from the mechanical controller
PCB.
10. Remove the four mounting screws to the drive gear solenoid
assembly and remove the assembly. Disconnect the remaining
2 pin connector from the frame.
11. Remove the two screws from the attraction roller drive assembly
and remove the assembly.
Repair Information 4-3