Disk Test/Clean - Lexmark Optra C Service Manual

To set the defaults:
1. Enter Diagnostics mode.
2. Select [PRINTER SETUP].
3. Select [Defaults].
4. Select [U.S.] or [NON U.S.].
5. Press Return to return to the Diagnostics mode main menu.

Disk Test/Clean

This is a 90 minute test that should be performed only on a disk that
contains bad data and is therefore unusable.
This test destroys all data on the disk by doing a multi-pass write/
read on every block of the disk. Bad blocks are flagged and removed
from use. If over 2000 bad blocks are found, the test stops and the
display indicates the disk must be replaced.
A message describing test progress is displayed during the test.
To test or clean the disk:
1. Enter Diagnostics mode.
2. Select [DEVICE TESTS].
3. Select [Disk Test/Clean].
4. Select [CONTINUE] to start the test, or [CANCEL] to return to
Diagnostics mode main menu.
5. Select [CANCEL] to interrupt the test.
6. Press Return to return to the Diagnostics mode main menu.
Diagnostic Aids 3-5