Table of Contents
Advertisement
* Loosen both fixation screws (indicated on next image) on the front
side of the retroprojector.
* Pull on the fixation on the back side of the retro and turn the projector
frame until service position 2 is reached. The fixation points will
automatically jump into the correct position when turning the frame
to this position.
* Open the cover plate of the electronics (front side of the retroprojector)
by loosening both retraining screws and pivot the plate downwards.
* The AC power input board is located on the left handside of the
projector.
* Loosen the retaining screws of the AC power input board and pull
out this board.
5975198 RETRODATA 808s 210397
2
AC power connection
5-3
Advertisement
Table of Contents
