Installation; Door Removal; Leg Installation - Viking Range 5 Series Installation Manual

DANGER

Installation

CAUTION
To avoid risk of personal injury or product
damages, DO NOT use the handle or
oven door to lift the oven. Remove door
before installation to ensure that it is not
used to lift the unit. DO NOT lift or carry
the door by the handle.
Removing the door must be done by your
dealer, or a qualified licensed plumber.

Door Removal

FOR YOUR SAFETY
1
Open door completely. Place pins,
supplied with unit, in pin hole. For personal safety,
ONLY use pins supplied with the unit.
3
Close until pins stop door.
12
2
Remove hinge trim screws. Take off hinge trim. Identify
right and left hinge for future re-installation.
4
Lift door up and out.

Leg Installation

1
Legs are packed in styrofoam top pack.
Note: Legs should be installed near to where
appliance is to be used, as they are
not secure for long transit.
3
Screw legs into couplings on all
four corners.
13
2
1
1
3
2
2
Note: It is strongly recommended
that a pallet or lift jack be used rather than tilting.
Raise unit about a foot. Unscrew temporary legs from
couplings.
4
Lower range gently to keep any undue strain from
legs and internal mounting hardware.