Table of Contents
Advertisement
General Information
READ AND FOLLOW ALL WARNING
Moving, Handling, and Unpacking
AND CAUTION INFORMATION
Remove and discard all packing materials,
WHEN INSTALLING THIS APPLIANCE.
including cardboard and tape on the outside
and inside of the range.
• All openings in the wall behind the
appliance and in the floor under the
Remove the cardboard top pack containing
appliance must be sealed.
the burner heads, burner caps, grates, leveling
legs and anti-tip bracket from the top of the
• DO NOT obstruct the flow of combustion
range.
and ventilation air.
DO NOT discard the anti-tip metal
CAUTION
bracket supplied with the range.
This is the anti-tip device and must
Avoid any damage to oven vents. The vents
be installed with the unit. Refer to
need to be unobstructed and open to provide
"Anti-tip Device Installation"
proper airflow for optimal oven performance.
section.
Some stainless steel parts may have a plastic
protective wrap which must be peeled off.
The interior should be washed thoroughly
with hot, soapy water to remove film
residues and any dust or debris before being
used, then rinsed and wiped dry. Solutions
stronger than soap and water are rarely
needed.
12
Installation
NOTICE
DO NOT use the handle or oven door to
lift the oven. Remove door before
installation to ensure that it is not used to
lift the unit. DO NOT lift or carry the door
by the handle.
Removing the door must be done by your
dealer, a qualified licensed plumber, or
certified gas installer.
Door Removal
1
Open door completely. Place pins,
supplied with unit, in pin holes. For personal safety,
ONLY use pins supplied with the unit.
3
Gently close until pins stop door.
13
2
Remove hinge trim screws.
Take off hinge trim.
4
Lift door up and out.
Advertisement
Table of Contents
