Storage, Unpacking And Handling; Contents Check List - Heatrae Sadia ELECTROMAX Installation & Servicing Instructions Manual

saves wasteful on-off cycling. For summer
use the boiler can be switched off on the
Electromax control panel, however a "pump
exercise" facility will energise the circulating
pump for a brief period every day to prevent
pump seizure through long periods without
use.
Time and temperature control of the central
heating is by means of a Programmable Room
Thermostat which is supplied loose with the
Electromax for remote siting in a suitable,
convenient position.
The necessary cold water mains supply controls
are supplied in a kit for installation on site in a
suitable, convenient position. These must be
fitted to comply with Building Regulation G3
and Water Fittings Regulations or Byelaws.

1.3 Storage, Unpacking and Handling

The Electromax is delivered in protective
expanded polystyrene
reinforced corner posts. The assembly is
shrunk wrapped in heavy duty polythene. The
Electromax unvented fitting kit is supplied
boxed and attached to the main assembly by
2 polypropylene bands. The assembly must be
stored upright, under cover in dry conditions.
Units must not be stacked. The packaging
must be removed prior to installation.
Note the weight of the product (Page 5)
and the handling instructions applied to the
packaging. If using a handling device, eg. a
sack barrow, to manually move the Electromax,
trucking must be done from the rear to avoid
damage to the outer panels.
The Electromax should be lifted and handled
by two persons. Handholds are provided in
the top rear panel, in both side panels and
underneath the Electromax assembly to
4 Installation & Servicing Instructions
packaging with
aid lifting. Stooping should be avoided and
protective clothing worn when necessary.
The packaging is recyclable and should be
disposed of in accordance with environmental
guidelines.

1.4 Contents check list

Within the Electromax packaging the following
components are supplied. Please check that
all parts are available before commencing
installation.
• Electromax unit
• Cold water combination valve comprising
pressure reducing valve, strainer, check
valve and expansion valve
• Unvented system expansion vessel (18
litre, pre-charged to 3.5 bar)
• Wall mounting bracket for expansion
vessel
• Programmable room thermostat
• Immersion heater key spanner
• Hose connection adaptor for primary
system drain valve
• Set of cable entry glands and blanking
plugs (3 x 20mm, 1 x 25.4mm)
• Installation manual
• User instructions
• Fitting template